LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2006 >> Relay 3.9 1, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Mechanical - 3.5L) >> Repair Instructions - Off Vehicle >> Camshaft Installation

Camshaft Installation

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Inspecting Camshaft Journals
    GM909621Courtesy of GENERAL MOTORS CORP.
  1. Coat the camshaft journals with clean engine oil.
  2. Coat the camshaft lobes with prelube P/N 12345501 or the equivalent.
  3. Install the camshaft using the following procedure:
    1. Install the camshaft sprocket bolt into the camshaft. Tighten finger tight only.
    2. Carefully rotate the camshaft while installing the camshaft into the camshaft bearings.
    4. Fig 2: View Of Camshaft Thrust Plate
    GM54981Courtesy of GENERAL MOTORS CORP.
  4. Install the camshaft thrust plate.
    5. NOTE: Refer to Fastener Notice in Cautions and Notices.
  5. Install the camshaft thrust plate screws.

    Tighten:  Tighten the camshaft thrust plate screws to 10 N.m (89 lb in).

    6. Fig 3: View Of Camshaft Position Sensor
    GM909619Courtesy of GENERAL MOTORS CORP.
  6. Install the camshaft position sensor.
  7. Install the camshaft position sensor bolt.

    Tighten:  Tighten the camshaft position sensor bolt to 10 N.m (89 lb in).

scientia non olet · About LEMON Manuals