LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2006 >> Relay 3.9 1, FWD >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel System Displays, Gauges And Console >> Diagnostic Information and Procedures >> Change Engine Oil Indicator Inoperative

Change Engine Oil Indicator Inoperative

Change Engine Oil Indicator Inoperative

Step Action Yes No
Schematic Reference: Instrument Cluster Schematics 
Connector End View Reference: Instrument Panel, Gages, and Console Connector End Views 
1 Did you perform the Diagnostic System Check - Vehicle? Go to Step 2  Go to Diagnostic System Check - Vehicle in Vehicle DTC Information
2
  1. Install a scan tool.
  2. Turn ON the ignition, with the engine OFF.
  3. With a scan tool, observe the Engine Oil Life Remaining in the instrument panel cluster (IPC) powertrain control module (PCM) data list.
Does the scan tool display zero percent while the Change Engine Oil message is inoperative?		 Go to Step 3  System OK
3 Replace the IPC. Refer to Control Module References in Computer/Integrating Systems for replacement, setup, and programming.
Did you complete the replacement?		 Go to Step 4  -
4 Operate the system in order to verify the repair.
Did you correct the condition?		 System OK Go to Step 2 
scientia non olet · About LEMON Manuals