LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2006 >> Relay 3.5 L, FWD >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Hydraulic Brakes >> Repair Instructions >> Master Cylinder Replacement >> Removal Procedure

Removal Procedure

CAUTION: Refer to Brake Fluid Irritant Caution .
NOTE: Refer to Brake Fluid Effects on Paint and Electrical Components Notice .
  1. Disconnect the electrical connector from the brake fluid level sensor.
    2. Fig 1: View of Master Cylinder
    GM288094Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the brake pipes from the master cylinder.
    3. IMPORTANT: Install a rubber cap or plug to the exposed brake pipe fitting ends in order to prevent brake fluid loss and contamination.
  3. Plug the open brake pipe ends.
  4. Remove master cylinder mounting nuts.
  5. Remove the master cylinder from the vehicle.
  6. Drain the master cylinder reservoir of all brake fluid.
scientia non olet · About LEMON Manuals