LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2006 >> Relay 3.5 L, FWD >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Hydraulic Brakes >> Repair Instructions >> Master Cylinder Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View of Master Cylinder
    GM288094Courtesy of GENERAL MOTORS CORP.
  1. Bench bleed the master cylinder. Refer to Master Cylinder Bench Bleeding .
  2. Install the master cylinder to the brake booster.
    3. NOTE: Refer to Fastener Notice.
  3. Install the master cylinder mounting nuts.

    Tighten:  Tighten the nuts to 29 N.m (21 lb ft).

  4. Remove the plugs from the brake pipes.
  5. Connect the brake pipes to the master cylinder.

    Tighten:  Tighten the fittings to 32 N.m (24 lb ft).

  6. Connect the electrical connector to the brake fluid level sensor.
  7. Bleed the hydraulic brake system. Refer to Hydraulic Brake System Bleeding (Manual)  or Hydraulic Brake System Bleeding (Pressure) .
scientia non olet · About LEMON Manuals