LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2006 >> Relay 3.5 L, FWD >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel System Displays, Gauges And Console >> Repair Instructions >> Instrument Panel Carrier Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View Of Bolts/Screws For IP Carrier And Cross Vehicle Beam To Hinge Pillar
    GM482588Courtesy of GENERAL MOTORS CORP.
  1. Position the I/P carrier to the body.
  2. NOTE: Refer to Fastener Notice .
  3. Install the bolts/screws which secure the I/P carrier to the body.

    Tighten:  Tighten the bolts/screws to 25 N.m (18 lb ft).

  4. Install the bolt holding the HVAC module to the bracket on the I/P carrier, this bolt is located under the right side window defogger duct.

    Tighten:  Tighten the bolts/screws to 2 N.m (18 lb in).

  5. Install the bolt holding the HVAC module to the bracket on the I/P carrier, this bolt is located under the left side window defogger duct.

    Tighten:  Tighten the bolts/screws to 2 N.m (18 lb in).

  6. Install the bolt holding the HVAC module to the bracket on the I/P carrier, this bolt is located on the rear right center of the I/P carrier.

    Tighten:  Tighten the bolts/screws to 2 N.m (18 lb in).

  7. Install the bolt holding the brake pedal bracket on the I/P carrier, this bolt is located on the upper rear side of the bracket.

    Tighten:  Tighten the bolts/screws to 25 N.m (18 lb ft).

  8. Install the ground wire bolts on the lower I/P carrier on the right and left sides.

    Tighten:  Tighten the bolts/screws to 2 N.m (18 lb in).

  9. Install the bolts holding the steering column support bracket on the cowl panel brace.

    Tighten:  Tighten the bolts/screws to 24 N.m (18 lb ft).

  10. Install the defroster duct. Refer to Defroster Air Outlet Duct Replacement .
  11. Install the center air outlet. Refer to Center Air Outlet Replacement .
  12. Install the I/P air outlet ducts. Refer to Instrument Panel Air Outlet Ducts Replacement .
  13. Install the A/C control module. Refer to HVAC Control Module Replacement .
  14. Install the EBCM. Refer to Electronic Brake Control Module Replacement .
  15. Install the BCM. Refer to Body Control Module Replacement .
  16. Install the wiring harness. Refer to Instrument Panel Wiring Harness Replacement .
  17. Install the I/P. Refer to Instrument Panel Assembly Replacement .
  18. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  19. Enable the SIR. Refer to SIR Disabling and Enabling and SIR Disabling and Enabling .