Cupholder Replacement

Fig 1: Cupholder Assembly

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
NOTE: Refer to Fastener Notice . Fastener Tightening Specifications: Refer to Fastener Tightening Specifications .Preliminary Procedure: Remove the front floor console reinforcement. Refer to Bracket, Reinforcement, Side Trim Panel Replacement - Front Floor Console .
1	Front Floor Console Cupholder Door Screws (Qty: 2) Tighten: 2 N.m (18 lb in)
2	Front Floor Console Cupholder Door
3	Cupholder Assembly Tip: Push forward on the cupholder, pushing it completely out of the track assembly, allowing the cupholder to fall out the bottom of the track. When installing cupholder, align the tabs of the cupholder to the track assembly. Ensure proper operation of the cupholder prior to reinstalling remaining components.