Installation Procedure

Install the compartment partially into the opening.

Fig 1: Installing I/P Compartment Bin
Courtesy of GENERAL MOTORS CORP.
Connect the electrical connectors to the BCM.
Route the glove box lamp wiring harness through the lamp opening. Connect the electrical connector.

Fig 2: Installing I/P Compartment Lamp Assembly
Courtesy of GENERAL MOTORS CORP.
Push on the lamp assembly until the assembly clicks into place.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Fig 3: Installing Glove Compartment Fastener

GM1230136

Courtesy of GENERAL MOTORS CORP.

Install the glove compartment fastener.
Tighten: Tighten the fasteners to 2.5 N.m (22 lb in).
Install the retainer.
Install the compartment door. Refer to Door Replacement - Instrument Panel (I/P) Compartment .