Charge Indicator Inoperative

Step	Action	Yes	No
Connector End View Reference: Engine Electrical Connector End Views or Engine Control Module (ECM) Connector End Views in Engine Controls - 2.2 L (L61) or Powertrain Control Module (PCM) Connector End Views in Engine Controls - 2.0 L (LSJ)
1	Did you perform the Diagnostic System Check - Vehicle?	Go to Step 2	Go to Diagnostic System Check - Vehicle in Vehicle DTC Information
2	Turn ON the ignition, with the engine OFF. Does the battery charge indicator illuminate?	Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems	Go to Step 3
3	Install a scan tool. With a scan tool, command the lamp and gages On and Off. Does the charge indicator turn On and Off with each command?	Go to Step 4	Go to Step 7
4	Test the generator turn on signal circuit for a short to ground or open. Refer to Circuit Testing and Wiring Repairs in Wiring Systems. Did you find and correct the condition?	Go to Step 8	Go to Step 5
5	Inspect for poor connections at the harness connector of the engine control module (ECM)/powertrain control module (PCM). Refer to Connector Repairs in Wiring Systems. Did you find and correct the condition?	Go to Step 8	Go to Step 6
6	IMPORTANT: The replacement ECM/PCM must be programmed. Replace the ECM/PCM. Refer to Control Module References in Computer/Integrating Systems for replacement, setup, and programming.Did you complete the replacement?	Go to Step 8	-
7	Replace the instrument panel cluster. Refer to Control Module References in Computer/Integrating Systems for replacement, setup, and programming. Did you complete the replacement?	Go to Step 8	-
8	Operate the system in order to verify the repair. Did you correct the condition?	System OK	Go to Step 2