Charge Indicator Always On
Charge Indicator Always On
| Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
| Connector End View Reference: Engine Electrical Connector End Views or Engine Control Module (ECM) Connector End Views in Engine Controls - 2.2 L (L61) or Powertrain Control Module (PCM) Connector End Views in Engine Controls - 2.0 L (LSJ) | ||||
| 1 | Did you perform the Diagnostic System Check for Engine Electrical? | - | Go to Step 2 | Go to Diagnostic System Check - Engine Electrical |
| 2 | Start the engine. Does the battery charge indicator remain illuminated? |
- | Go to Step 3 | Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems |
| 3 |
|
10.5-17.5 V | Go to Step 4 | Go to Charging System Test |
| 4 | With a scan tool, command the lamp and gages On and Off. Does the charge indicator turn On and Off with each command? |
- | Go to Step 5 | Go to Step 6 |
| 5 |
IMPORTANT:
The replacement engine control module (ECM)/powertrain control module (PCM) must be programmed. Replace the ECM/PCM. Refer to Engine Control Module (ECM) Replacement
in Engine Controls - 2.2 L (L61) or Powertrain Control Module (PCM) Replacement
in Engine Controls - 2.0 L (LSJ).Did you complete the replacement? |
- | Go to Step 7 | - |
| 6 | Replace the instrument panel cluster. Refer to Instrument Panel Cluster (IPC) Replacement
in Instrument Panel, Gages and Console. Did you complete the replacement? |
- | Go to Step 7 | - |
| 7 | Operate the system in order to verify the repair. Did you correct the condition? |
- | System OK | Go to Step 2 |