Brake Warning Indicator Always On

Step	Action	Yes	No
Schematic Reference: Brake Warning System Schematics Connector End View Reference: Body Control System Connector End Views in Body Control System
1	Did you perform the Hydraulic Brake Diagnostic System Check?	Go to Step 2	Go to Diagnostic System Check - Hydraulic Brakes
2	Turn ON the ignition, with the engine OFF. Release the park brake. With a scan tool, observe the Park Brake Switch parameter in the Body Control Module data list. Does the scan tool indicate that the Park Brake Switch parameter is Off?	Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems	Go to Step 3
3	Turn OFF the ignition. Disconnect the park brake switch. Turn ON the ignition, with the engine OFF. With a scan tool, observe the Park Brake Switch parameter. Does the scan tool indicate that the Park Brake Switch parameter is Off?	Go to Step 5	Go to Step 4
4	Test the signal circuit of the park brake switch for a short to ground. Refer to Circuit Testing and Wiring Repairs in Wiring Systems. Did you find and correct the condition?	Go to Step 9	Go to Step 6
5	Inspect for poor connections at the harness connector of the park brake switch. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems. Did you find and correct the condition?	Go to Step 9	Go to Step 7
6	Inspect for poor connections at the harness connector of the body control module (BCM). Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems. Did you find and correct the condition?	Go to Step 9	Go to Step 8
7	Replace the park brake switch. Refer toPark Brake Warning Lamp Switch Replacement in Park Brake. Did you complete the repair?	Go to Step 9	-
8	Replace the body control module (BCM). Refer toBody Control Module Replacement in Body Control System. Did you complete the repair?	Go to Step 9	-
9	Operate the system in order to verify the repair. Did you correct the condition?	System OK	Go to Step 2