LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2004 >> Ion 1 Standard >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel System Displays, Gauges And Console >> Repair Instructions >> Instrument Panel (I/P) Trim Panel Replacement - Right >> Installation Procedure

Installation Procedure

  1. Verify that the retaining clips are installed on the I/P trim panel and that no clips remain in the I/P center trim panel.
  2. Align the locating pins and the retaining clips with the I/P. Push on the I/P trim panel in order to secure.
  3. Pull up on the upper edge of the trim panel to verify that the bracket is hooked onto the I/P retainer.
  4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  5. Install the I/P trim panel screws.

    Tighten:  Tighten the screws to 2.5 N.m (22 lb in).

  6. Fig 1: View Of Right I/P Trim Panel
    GM877808Courtesy of GENERAL MOTORS CORP.
  7. Slide the I/P inflatable restraint module up into position.
  8. Install the bolts to the restraint module.

    Tighten:  Tighten the bolts to 10 N.m (88 lb in).

  9. Fig 2: View Of I/P Inflatable Restraint Module Bolts
    GM877723Courtesy of GENERAL MOTORS CORP.
  10. Align the locating pins with the I/P.
  11. Push in on the I/P compartment in order to secure the compartment in place.
  12. Install the I/P compartment screws.

    Tighten:  Tighten the screws to 2.5 N.m (22 lb in).

  13. Fig 3: View Of I/P Compartment
    GM877781Courtesy of GENERAL MOTORS CORP.
  14. Install the defroster grille. Refer to Defroster Grille Replacement .
  15. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 5 in SIR.