Engine Oil Pressure Indicator Always On
Engine Oil Pressure Indicator Always On
| Step | Action | Yes | No |
|---|---|---|---|
| Schematic Reference: Instrument Cluster Schematics | |||
| 1 | Did you perform the Diagnostic System Check - Instrument Cluster? | Go to Step 2 | Go to Diagnostic System Check - Instrument Cluster |
| 2 | Start the engine. Does the engine oil pressure indicator illuminate after the displays test? |
Go to Step 3 | Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems |
| 3 |
|
Go to Step 10 | Go to Step 4 |
| 4 |
|
Go to Step 6 | Go to Step 5 |
| 5 | Test the signal circuit of the oil pressure switch signal for a short to ground. Refer to Circuit Testing
and to Wiring Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 11 | Go to Step 7 |
| 6 | Inspect for poor connections at the harness connector of the engine oil pressure switch. Refer to Testing for Intermittent Conditions and Poor Connections
and to Connector Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 11 | Go to Step 8 |
| 7 | Inspect for poor connections at the harness connector of the ECM/PCM. Refer to Testing for Intermittent Conditions and Poor Connections
and to Connector Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 11 | Go to Step 9 |
| 8 | Replace the engine oil pressure switch. Refer to Engine Oil Pressure Sensor and/or Switch Replacement
in Engine Mechanical - 2.2L or to Engine Oil Pressure Sensor and/or Switch Replacement
in Engine Mechanical - 2.0L (LSJ). Did you complete the replacement? |
Go to Step 11 | - |
| 9 |
IMPORTANT:
Program the replacement ECM/PCM. Replace the ECM/PCM. Refer to Engine Control Module (ECM) Replacement
in Engine Controls - 2.2L (L61) or to Powertrain Control Module (PCM) Replacement
in Engine Controls - 2.0L (LSJ).Did you complete the replacement? |
Go to Step 11 | - |
| 10 | Replace the instrument panel cluster (IPC). Refer to Instrument Panel Cluster (IPC) Replacement . Did you complete the replacement? |
Go to Step 11 | - |
| 11 | Operate the system in order to verify the repair. Did you correct the condition? |
System OK | Go to Step 2 |