Installation Procedure
Courtesy of GENERAL MOTORS CORP.
- Holding lens/mask assembly by the ends and face up, align the reset knob with the hole in the lens.
- Start the lens/mask tabs into the slots in the housing. Beginning at the top of the cluster, seat the two housing tabs into the lens/mask slots.
- Press down on the top of the lens/mask around the edge to fully seat all of the clips.
- Verify that all gages and clips are seated correctly, and that there are no debris or markings on the lens or dial faces.
- Install the instrument panel cluster assembly. Refer to Instrument Panel Cluster (IPC) Replacement .