LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2003 >> L300 >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel, Gages, And Console >> Repair Instructions >> Compartment Replacement - Instrument Panel (I/P) >> Installation Procedure

Installation Procedure

    Fig 1: Locating Body Control Module Electrical Connectors
    GM896914Courtesy of GENERAL MOTORS CORP.
  1. Install the compartment partially into the opening.
  2. Connect the electrical connectors to the BCM.
    3. Fig 2: Installing I/P Compartment Lamp Assembly
    GM896878Courtesy of GENERAL MOTORS CORP.
  3. Route the glove box lamp wiring harness through the lamp opening. Connect the electrical connector.
  4. Push on the lamp assembly until the assembly clicks into place.
    5. NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  5. Install the glove compartment fastener.

    Tighten:  Tighten the fasteners to 2.5 N.m (22 lb in).

    6. Fig 3: Removing & Installing Compartment Lamp Assembly
    GM1230136Courtesy of GENERAL MOTORS CORP.
  6. Install the retainer.
  7. Install the compartment door. Refer to Door Replacement - Instrument Panel (I/P) Compartment .
scientia non olet · About LEMON Manuals