Installation Procedure
- Install the I/P to the vehicle.
- Install the I/P fasteners.
Tighten: Tighten the bolts to 20 N.m (15 lb ft).
- Install all harness clips to the I/P.
- Install the I/P to floor bracket fasteners.
Tighten: Tighten the bolts to 20 N.m (15 lb ft).
- Install the DLC to the I/P.
- Install the hood release handle. Refer to Hood Latch Release Cable Replacement in Body Front End.
- Install the I/P compartment. Refer to Compartment Replacement - Instrument Panel (I/P) .
- Install the steering wheel. Refer to Steering Column Replacement in Steering Wheel and Column.
- Install the harness clips to the I/P.
- Install the I/P cluster. Refer to Instrument Panel Cluster (IPC) Replacement .
- Install the right air outlet louver. Refer to Deflector Replacement - Instrument Panel Air - Right in Heating, Ventilation and Air Conditioning.
- Install the left air outlet louver. Refer to Deflector Replacement - Instrument Panel Air - Left in Heating, Ventilation and Air Conditioning.
- Install the defroster grille. Refer to Defroster Grille Replacement .
- Remove the HVAC control. Refer to HVAC Control Assembly Replacement in HVAC - Manual.
- Install the radio. Refer to Radio Replacement in Entertainment.
- Install the center console. Refer to Console Replacement .
- Enable the passenger SIR system. Refer to DISABLING & ACTIVATING AIR BAG SYSTEM ZONE 5 in Airbag.
- Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Battery.
- Verify the operation of all components in the I/P.
NOTE:
Refer to FASTENER NOTICE
in Cautions and Notices.