LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2003 >> Ion 1 Standard >> Repair and Diagnosis (Single Page) >> Electrical >> Motors, Switches, Relays >> Battery >> Repair Instructions >> Battery Positive Cable Replacement (Underhood Junction Block to Starter) >> Removal Procedure

Removal Procedure

IMPORTANT:
  • Always use replacement cables that are of the same type, diameter and length of the cables that you are replacing.
  • Always route the replacement cable the same way as the original cable.
  1. Disconnect the negative battery cable from the battery. Refer to Battery Negative Cable Disconnect/Connect Procedure .
    2. Fig 1: View Of Engine Electrical Center
    GM873343Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the positive battery cable (1) from the under hood junction block terminal.
  3. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  4. Disconnect the positive cable from the negative cable near the transmission.
    5. Fig 2: Identifying Starter Electrical Connectors
    GM758469Courtesy of GENERAL MOTORS CORP.
  5. Disconnect the positive battery cable (4) from the starter.
  6. Remove the battery cable from the vehicle.
scientia non olet · About LEMON Manuals