LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2003 >> Ion 1 Standard >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Seats >> Repair Instructions >> Seat Cushion Outer Trim Panel Replacement - Front Seat (Non-Fold Flat) >> Installation Procedure

Installation Procedure

    Fig 1: View Of Front Seat Cushion Outer Trim Panel - Non-Fold Flat
    GM891359Courtesy of GENERAL MOTORS CORP.
  1. Install the outer trim panel to the front bucket seat cushion.
    2. NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the screws to the outer trim panel of the front bucket seat cushion.

    Tighten:  Tighten the screws to 1 N.m (9 lb in).

    3. Fig 2: View Of Riser Trim Handle
    GM891478Courtesy of GENERAL MOTORS CORP.
  3. For vehicles equipped with 4-way adjustable seats, install the riser trim handle on the driver side by pushing the handle.
    4. Fig 3: View Of Recliner Handle
    GM891296Courtesy of GENERAL MOTORS CORP.
  4. Install the recliner handle by pushing firmly on the handle.
  5. Install the front seat. Refer to Seat Replacement - Front Bucket .
scientia non olet · About LEMON Manuals