LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2003 >> Ion 1 Standard >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Seats >> Repair Instructions >> Seat Back Cover, Pad & Back Panel Replacement - Rear Split Folding Seat >> Removal Procedure

Removal Procedure

    Fig 1: Exploded View Of Rear Seat Back
    GM875189Courtesy of GENERAL MOTORS CORP.
  1. Remove the rear seat back. Refer to Seat Back Replacement - Rear Split Folding .
    2. Fig 2: View Of Rear J-Hook Retainers
    GM873559Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the upper and lower J-hook retainers.
    3. Fig 3: View Of Rear Push-In Retainers
    GM873617Courtesy of GENERAL MOTORS CORP.
  3. Lift the seat back cover enough to expose the rear push-in retainers.
  4. Remove the push-in retainers.
    5. Fig 4: View Of Rear Seat Back Hook & Loop Fasteners
    GM873612Courtesy of GENERAL MOTORS CORP.
    NOTE: Use care when disengaging the hook and loop fasteners. The hook end may pull from the seat foam pad, requiring foam pad replacement.
  5. Carefully disengage the hook and loop retainers and remove the seat back trim cover.
  6. Remove the seat back pad from the seat back panel.
scientia non olet · About LEMON Manuals