Rear Compartment Lamp(s) Inoperative
Rear Compartment Lamp(s) Inoperative
| Step | Action | Yes | No |
|---|---|---|---|
| Schematic Reference: Interior Lights Schematics | |||
| 1 | Did you perform the Lighting System Diagnostic System Check? | Go to Step 2 | Go to Diagnostic System Check - Lighting Systems |
| 2 |
|
Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems | Go to Step 3 |
| 3 |
|
Go to Step 4 | Go to Step 9 |
| 4 | Connect the test lamp between the courtesy lamps supply voltage circuit of the rear compartment lamp and the rear compartment lamp control circuit. Does the test lamp illuminate? |
Go to Step 7 | Go to Step 5 |
| 5 |
|
Go to Step 6 | Go to Step 10 |
| 6 | Test for an open or high resistance in the ground circuit of the rear compartment lid release actuator. Refer to Circuit Testing
and Wiring Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 13 | Go to Step 8 |
| 7 | Inspect for poor connections at the harness connector of the rear compartment lamp. Refer to Testing for Intermittent Conditions and Poor Connections
and Connector Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 13 | Go to Step 11 |
| 8 | Inspect for poor connections at the harness connector of the rear compartment lid release actuator. Refer to Testing for Intermittent Conditions and Poor Connections
and Connector Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 13 | Go to Step 12 |
| 9 | Repair an open, high resistance, or short to ground in the courtesy lamp supply voltage circuit of the rear compartment lamp. Refer to Circuit Testing
and Wiring Repairs
in Wiring Systems. Did you complete the repair? |
Go to Step 13 | - |
| 10 | Repair an open or high resistance in the rear compartment lamp control circuit. Refer to Circuit Testing
and Wiring Repairs
in Wiring Systems. Did you complete the repair? |
Go to Step 13 | - |
| 11 | Replace the rear compartment lamp assembly. Refer to Cargo Lamp Replacement . Did you complete the replacement? |
Go to Step 13 | - |
| 12 | Replace the rear compartment lid release actuator. Refer to Latch Replacement - Rear Compartment Lid
in Body Rear End. Did you complete the replacement? |
Go to Step 13 | - |
| 13 | Operate the system in order to verify the repair. Did you correct the condition? |
System OK | Go to Step 3 |