LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2003 >> Ion 1 Standard >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Interior/Exterior Trim >> Interior Trim >> Repair Instructions >> Garnish Molding Replacement - Center Pillar Upper >> Removal Procedure

Removal Procedure

    Fig 1: View Of Height Adjuster Knob
    GM876404Courtesy of GENERAL MOTORS CORP.
  1. Remove the height adjuster knob for the seat belt webbing:
    1. Insert a small awl into the hole underneath the knob and push.
    2. Lift up on the bottom of the knob. Unsnap the top of the knob from the seat belt height adjuster.
    2. Fig 2: View Of Center Pillar Upper Trim
    GM888379Courtesy of GENERAL MOTORS CORP.
  2. Remove the bolt from the adjustable guide loop on the front seat belt.
  3. Pull the lower end of the center trim inboard to disengage the lower clip.
  4. Remove the center pillar trim from the upper trim clip by sliding the trim up.
scientia non olet · About LEMON Manuals