Removal Procedure
- Disable the SIR system. Refer to DISABLING & ACTIVATING AIR BAG SYSTEM in AIR BAG RESTRAINT SYSTEMS article in RESTRAINTS.
- Disable the head curtain inflator modules, if equipped. Refer to DISABLING & ACTIVATING AIR BAG SYSTEM in AIR BAG RESTRAINT SYSTEMS article in RESTRAINTS.
- Apply the parking brake lever.
Courtesy of GENERAL MOTORS CORP.
Courtesy of GENERAL MOTORS CORP.
- Remove the power window/mirror switch or storage tray.
- Exert pressure on the rear with your hand.
- Using a small flat blade screwdriver, carefully lift the switch.
- Lift up and out.
- Disconnect the electrical connectors by locating the retention tabs and disengaging the connectors.
Courtesy of GENERAL MOTORS CORP.
- Adjust the front seats to the maximum forward position.
- Remove the rear console fasteners.
Courtesy of GENERAL MOTORS CORP.
- Adjust the front seats to the maximum rear position.
- Remove the left and right lower trim panel extensions by pulling outward at the dual lock locations.
- Rotate the panels outward to disengage the hinges from the console.
Courtesy of GENERAL MOTORS CORP.
- Remove the front console fasteners.
- Move the console rearward.
- Disengage the retaining tabs and disconnect the power outlet connector.
Courtesy of GENERAL MOTORS CORP.
- On automatic transaxle equipped vehicles, press and tape the gear selector button IN to clear the shifter opening.
- Select neutral for the transaxle gear on automatic transaxles.
- Maneuver the console beyond the gear selector and parking brake by lifting the rear of the console.
- Remove the console from the vehicle.