LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2002 >> SC2 Automatic, MP6 >> Repair and Diagnosis (Single Page) >> Body & Frame >> Exterior/Interior Trim >> Interior Trim -- "S" Series >> Repair Instructions >> Trim Finish Molding Replacement - Body Lock Pillar Lower (Sedan/Wagon) >> Removal Procedure

Removal Procedure

    Fig 1: Trim Finish Molding - Body Lock Pillar Lower
    GM867263Courtesy of GENERAL MOTORS CORP.
  1. Remove the rear seat cushion. Refer to Rear Seat Cushion Replacement (Coupe) or Rear Seat Cushion Replacement (Sedan/Wagon) in Seats.
  2. Remove the rear seat carpet retainer molding.
  3. Lower the rear seat back.
  4. Remove the body lock trim finish molding by pulling firmly, starting at the bottom of the molding to disengage the clips.
  5. Slide the molding out from under the body lock pillar upper trim finish molding and the weatherstrip.
scientia non olet · About LEMON Manuals