LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2002 >> SC2 Automatic, MP6 >> Repair and Diagnosis (Single Page) >> Body & Frame >> Exterior/Interior Trim >> Interior Trim -- "S" Series >> Repair Instructions >> Garnish Molding Replacement - Wheelhouse (Wagon) >> Removal Procedure

Removal Procedure

    Fig 1: Rear Wheelhouse Trim Finish Panel
    GM867214Courtesy of GENERAL MOTORS CORP.
  1. Remove the rear wheelhouse trim finish panel by pulling up to disengage the clips. Slip the shoulder belt out of trim finish panel at the slit in the cover.
    2. Fig 2: body lock pillar molding
    GM867227Courtesy of GENERAL MOTORS CORP.
  2. Remove the body lock pillar molding. Refer to Trim Finish Molding Replacement - Body Lock Pillar Lower (Sedan/Wagon) .
    3. Fig 3: Headliner At Left Side D-Pillar Location
    GM866919Courtesy of GENERAL MOTORS CORP.
  3. Remove the headliner rear header trim panel assembly by pulling at the clip locations to disengage the clips.
    4. Fig 4: Corner Upper Garnish Moldings
    GM867189Courtesy of GENERAL MOTORS CORP.
  4. Remove the corner upper garnish molding by pulling at the clip locations to disengage the clips.
    5. Fig 5: Rear End Trim Finish Panel
    GM867203Courtesy of GENERAL MOTORS CORP.
  5. Remove the rear end trim finish panel by pulling to disengage the clips.
    6. Fig 6: Wheelhouse Garnish Molding
    GM867219Courtesy of GENERAL MOTORS CORP.
  6. Remove the rear cargo net retainers by twisting in a counterclockwise direction.
  7. Remove the wheelhouse garnish molding by pulling at the clip locations to disengage the clips.
scientia non olet · About LEMON Manuals