LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2002 >> SC2 Automatic, MP6 >> Repair and Diagnosis (Single Page) >> Body & Frame >> Exterior/Interior Trim >> Interior Trim -- "S" Series >> Repair Instructions >> Energy Absorber Pad Replacement - Center Pillar Lower (Sedan/Wagon) >> Removal Procedure

Removal Procedure

CAUTION: If energy absorber is removed or damaged it must be replaced with a new part. If omitted, the vehicle will not meet federal motor vehicle safety standards (FMVSS), subjecting the retailer to possible civil penalties for making the vehicle inoperative to the FMVSS, and increasing the risk of injury to the vehicle occupants.
    Fig 1: Energy Absorber Pad
    GM869348Courtesy of GENERAL MOTORS CORP.
  1. Remove the center pillar lower trim finish panel. Refer to Center Pillar Garnish Molding Replacement (Sedan/Wagon 2nd Design)  or Center Pillar Garnish Molding Replacement (Sedan/Wagon) .
  2. Remove the energy absorber by pulling.
scientia non olet · About LEMON Manuals