LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2002 >> SC2 Automatic, MP6 >> Repair and Diagnosis (Single Page) >> Body & Frame >> Exterior Body Panels >> Bumpers -- "S" Series >> Repair Instructions >> Front Bumper Fascia Replacement (Coupe) >> Installation Procedure

Installation Procedure

    Fig 1: Fascia, Side Marker Push Nuts, Fascia Brackets, Retainer Nuts And Emblem.
    GM866376Courtesy of GENERAL MOTORS CORP.
  1. If installing a new fascia, transfer the side marker push nuts, fascia brackets, retainer nuts and the emblem.
  2. Position the fascia on the front energy absorber.
    3. Fig 2: Positioning Fascia On Front Energy Absorber
    GM866795Courtesy of GENERAL MOTORS CORP.
  3. Feed the side marker wiring harness through each opening.
  4. Install the fascia ends over the shoulder bolts extending down from fender upper support bracket assembly. The holes in fascia are slotted to allow for installation without retaining the bolts.
    5. Fig 3: Upper And Lower Fascia Retainers (Coupe)
    GM866329Courtesy of GENERAL MOTORS CORP.
  5. Connect the wiring harness to the front side marker lamps and install the front side marker lamps to the fascia.
    6. Fig 4: Wheelhouse Retainers (Coupe)
    GM866801Courtesy of GENERAL MOTORS CORP.
  6. Install the retainers from the wheelhouse to the fascia.
scientia non olet · About LEMON Manuals