LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2002 >> SC2 Automatic, MP6 >> Repair and Diagnosis (Single Page) >> Body & Frame >> Exterior Body Panels >> Body Rear End -- "S" Series >> Repair Instructions >> Quarter Panel Replacement - Bolt On (Wagon) >> Installation Procedure

Installation Procedure

    Fig 1: Left Quarter Panel,
    GM866789Courtesy of GENERAL MOTORS CORP.
  1. Position the quarter panel to the body. Position the rear, then the top, then the front.
  2. Install ythe bolts loosely.
  3. Align the quarter panel with the rear door and the lift gate as necessary.
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Tighten the bolts in sequence as shown in the illustration.

    Tighten:  Tighten the quarter panel bolts (Wagon) to 6 N.m (53 lb in).

  5. Close the lift gate and inspect the gap.
  6. If installing the left quarter panel, install the fuel door release latch and the retainer.
  7. Install the quarter panel fasteners to install the rear of the rocker panel cover.
    8. Fig 2: Inner Wheelhouse Panel
    GM865772Courtesy of GENERAL MOTORS CORP.
  8. Install the inner wheelhouse panel outer plastic fasteners.
    9. Fig 3: Tail Lamp
    GM867241Courtesy of GENERAL MOTORS CORP.
  9. Install the tail lamp. Refer to Tail Lamp Replacement (Coupe) or Tail Lamp Replacement (Wagon) or Tail Lamp Replacement (Sedan) in Lighting Systems.
  10. Install the rear fascia. Refer to Rear Bumper Fascia Replacement (Coupe) or Rear Bumper Fascia Replacement (Sedan) or Rear Bumper Fascia Replacement (Wagon) in Bumpers.
scientia non olet · About LEMON Manuals