Removal Procedure
Courtesy of GENERAL MOTORS CORP.
- Remove the rear fascia. Refer to Rear Bumper Fascia Replacement (Coupe)
or Rear Bumper Fascia Replacement (Sedan)
or Rear Bumper Fascia Replacement (Wagon)
in Bumpers.
Courtesy of GENERAL MOTORS CORP.
- Remove the rear wheelhouse panel from the quarter panel being removed. Refer to Rear Wheelhouse Liner Panel Replacement .
Courtesy of GENERAL MOTORS CORP.
- Remove the tail lamp. Refer to Tail Lamp Replacement (Coupe)
or Tail Lamp Replacement (Wagon)
or Tail Lamp Replacement (Sedan)
in Lighting Systems.
Courtesy of GENERAL MOTORS CORP.
- Remove the rocker panel cover. Refer to Rocker Panel Molding Replacement (Sedan/Wagon)
or Rocker Panel Molding Replacement (Coupe)
in Exterior Trim.
- If removing the left quarter, open the fuel door and remove the pushpins from the upper, center, and lower appliques attached to the quarter panel.
- Remove the retaining bolts behind the closeout pieces from the quarter panel.
Courtesy of GENERAL MOTORS CORP.
- Close the door.
Courtesy of GENERAL MOTORS CORP.
- If removing the left quarter panel, open the fuel door and remove the latch retainer nut.
- Reach through the tail lamp opening to remove the cable from the fill pocket by twisting 1/4 turn clockwise.
- Remove the plastic fastener from the safety strap on the fuel cap.
- Remove the fuel cap.
- Remove the rubber surrounding the fuel inlet pipe and replace the cap.
Courtesy of GENERAL MOTORS CORP.
- Remove the rear quarter attaching bolts behind and underneath the inside tail lamp opening.
- Remove the retaining attaching bolts from the quarter panel.
- With all of the bolts removed, pull out the rear of the quarter panel to disconnect the attaching clip from the side window encapsulated molding.
- Remove the quarter panel.