LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2002 >> SC2 Automatic, MP6 >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Seats -- "S" Series >> Repair Instructions >> Seat Back Latch Beam Replacement - Rear (Wagon) >> Installation Procedure

Installation Procedure

  1. Install the passenger side seat back beam front cover to the right side front location of the beam assembly by lifting the edge of the cover over the beam assembly.
  2. Place the seat back beam onto the rear seat back assembly aligning the holes in the beam with the seat back studs. Snug the attaching nuts enough to hold the seat back beam in place.
  3. Latch and unlatch the seat back assembly three to four times to adjust the beam on the rear seat back assembly. Insure smooth operation.
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Tighten the attaching nuts.

    Tighten:  Tighten the rear folding seat back beam fasteners to 18 N.m (13 lb ft).

  5. Install the seat back beam rear cover to the seat back beam assembly with the push type fasteners.
  6. Install the rear seat back assembly to the vehicle. Refer to Rear Split Folding Seat Back Replacement .
  7. Check the seat back latch function after installation.
scientia non olet · About LEMON Manuals