Removal Procedure
IMPORTANT:
LHD shown, RHD similar.
- Remove the seat from the vehicle. Refer to Front Seat Replacement - Bucket .
- On the driver's seat, rotate the seat riser knob to the full up position.
- Remove the recliner handle.
- On the driver's side, remove the seat riser knob cover and fastener.
- Remove the seat adjuster side cover.
- On the driver's side, install the riser knob without the screw. Lower the cushion.
- Disengage the J-strip. Refer to the following:
- Seat Cover (1)
- Cushion Frame (2)
- Foam Pad (3)
- Cross Tube (4)
- Seat Cover J-Strip (5)
- On the driver's side, raise the cushion and remove the riser knob.
- On the driver's side, raise the cushion and remove the riser knob.
- Remove the lumbar knob by pulling.
- Remove the lumbar actuator fasteners.
- Remove the lumbar actuator cable assembly by pushing rearward.
- Thread the lumbar cable back above the riser bar to the side of the seat back.
- Remove the bolts at the sides of the seat cushion and remove the seat cushion.
- Disengage the remaining seat cover J-strips.
- Remove the seat cushion frame.
- Pull up to expose the hog rings in the foam pad. Remove the hog rings, and remove the cover. Refer to the following:
- Hog Rings to center listing wire (1)
- Hog Rings to horizontal listing wire (2)