LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2002 >> SC2 Automatic, MP6 >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Interior/Exterior Trim >> Interior Trim -- "S" Series >> Repair Instructions >> Windshield Garnish Molding Replacement (1st Design Coupe) >> Removal Procedure

Removal Procedure

IMPORTANT:
  • LHD shown, RHD similar
  • Right side shown, left side similar
    Fig 1: Clip Locations
    GM868083Courtesy of GENERAL MOTORS CORP.
  1. Remove the instrument panel upper trim panel. Refer to Instrument Panel Upper Trim Plate Replacement in Instrument Panel, Gages, and Console.
    2. Fig 2: Seat Belt Retractor Cover
    GM868577Courtesy of GENERAL MOTORS CORP.
  2. For the left side windshield garnish molding, remove the seat belt retractor cover by pulling at the clip locations.
  3. Starting at the upper rear section of the molding, pull firmly at the clip locations to disengage the molding from the vehicle.
scientia non olet · About LEMON Manuals