LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2002 >> SC2 Automatic, MP6 >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Interior/Exterior Trim >> Interior Trim -- "S" Series >> Repair Instructions >> Finish Panel Replacement - Rear Window (Coupe) >> Removal Procedure

Removal Procedure

    Fig 1: Coathook
    GM868082Courtesy of GENERAL MOTORS CORP.
  1. Remove the coathooks for the 1st design vehicles only.

    2. Fig 2: Seatbelt Upper Anchor
    GM868115Courtesy of GENERAL MOTORS CORP.
  2. Unsnap the seat belt bolt covers.
  3. Loosen the Torx(R) fasteners and rotate the presenter arms forward to disengage the presenter arm guide notches from the spaceframe.
  4. Remove the presenter arms and the seat belt units. Refer to Seat Belt Retractor Replacement - Right Front (Coupe) in Seat Belts.
    5. Fig 3: Clip Locations
    GM868083Courtesy of GENERAL MOTORS CORP.
  5. For the 1st design vehicles only:, Disengage the rear clips of the windshield garnish moldings by pulling the moldings at the clip location to allow the removal of the quarter window garnish moldings.
    6. Fig 4: Quarter Window Garnish Molding & Related Components
    GM868060Courtesy of GENERAL MOTORS CORP.
  6. Remove the quarter window garnish upper moldings. Refer to Garnish Molding Replacement - Quarter Window Upper (Coupe Left Side 1st Design)  or Garnish Molding Replacement - Quarter Window Upper (Coupe Left Side 2nd Design) . Refer to the following:
    • Defogger Lead (1)
    • Defogger Notch (2)
    • Interlock Tab (3)
  7. Lower the rear seat back.
    8. Fig 5: Tether Anchor
    GM869095Courtesy of GENERAL MOTORS CORP.
  8. Remove the top tether anchor covers.
  9. Remove the push pin rivets and lift the rear window trim up and over the top tether anchors.
scientia non olet · About LEMON Manuals