LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2002 >> SC2 Automatic, MP6 >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Horns -- "S" Series >> Repair Instructions >> Horn Replacement (Sedan/Wagon) >> Installation Procedure

Installation Procedure

  1. Install the horn assembly, lining up the horn bracket to rail.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the horn bolt.

    Tighten:  Tighten the horn bracket-to-frame rail bolt to 10 N.m (89 lb in).

  3. Connect the horn connector.
    4. Fig 1: HeadlampHousing
    GM864928Courtesy of GENERAL MOTORS CORP.
  4. Install the headlamp bulb sockets and the turn signal socket into the headlamp housing. Rotate the sockets to lock in place.
  5. Slide the headlamp housing into place on the vehicle.
  6. Align the housing and install the attaching bolts.

    Tighten:  Tighten the headlamp housing-to-front clip fasteners to 6 N.m (53 lb in).

    7. CAUTION: Halogen bulbs contain a gas under pressure. Handling a bulb improperly could cause it to shatter into flying glass fragments. To help avoid personal injury:
    • Turn off the headlamp switch and allow the bulb to cool before changing bulbs. Leave the headlamp switch off until the bulb change is complete.
    • Always wear eye protection when changing a halogen bulb.
    • Handle the bulb only by its base. Avoid touching the glass.
    • Do not drop or scratch the bulb. Keep moisture away.
    • Place the used bulb in the new bulb's carton and dispose of it properly. Keep halogen bulbs out of the reach of children.
  7. Check the headlamp aim. Adjust if required. Refer to Headlamp Aiming in Lighting Systems.
scientia non olet · About LEMON Manuals