LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2002 >> SC2 Automatic, MP6 >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Headlights >> Lighting Systems -- "S" Series >> Repair Instructions >> Headlamp Assembly or Headlamp Bulb Replacement (Sedan/Wagon) >> Removal Procedure

Removal Procedure

Fig 1: Headlamp Assembly
GM865212Courtesy of GENERAL MOTORS CORP.
CAUTION: Halogen bulbs contain a gas under pressure. Handling a bulb improperly could cause it to shatter into flying glass fragments. To help avoid personal injury:
  • Turn off the headlamp switch and allow the bulb to cool before changing bulbs. Leave the headlamp switch off until the bulb change is complete.
  • Always wear eye protection when changing a halogen bulb.
  • Handle the bulb only by its base. Avoid touching the glass.
  • Do not drop or scratch the bulb. Keep moisture away.
  • Place the used bulb in the new bulb's carton and dispose of it properly. Keep halogen bulbs out of the reach of children.
  1. Remove the headlamp attachment bolts, 1 upper and 1 lower connecting to the headlamp mounting bracket.
  2. Disconnect the headlamp bulb and the turn signal sockets from the headlamp housing.
  3. Pull the center edge of the housing forward, then slide the headlamp housing toward the center of the vehicle to remove.
scientia non olet · About LEMON Manuals