Installation Procedure
- Apply the parking brake.
- Adjust the front seats to the maximum rear position.
- Recline the driver's and passenger's seat backs as far down as possible.
- Select neutral for the transaxle gear on automatic transaxles.
- Hold the front end of the console down and he rear end up.
- Position all of the harnesses so they can be accessed.
- Maneuver the console over the gear selector lever and past the brake lever.
- Connect the power outlet electrical connector.
- On automatic transaxle equipped vehicles, remove the tape from the gear selector button.
- Install the rear console fasteners.
Tighten: Tighten the console rear fasteners to 2.2 N.m (19 lb in).
- Install the front console fasteners.
Tighten: Tighten the console front fasteners to 2.2 N.m (19 lb in).
- Install the left and right extension panels by inserting the hinges into the console.
- Rotate closed and push in at the dual lock locations.
- Connect the power window switch connectors, if equipped.
- Install the power window switch or storage tray, depending on the equipment.
- Enable the SIR system. Refer to DISABLING & ACTIVATING AIR BAG SYSTEM in AIR BAG RESTRAINT SYSTEMS article in RESTRAINTS.
- Enable the head curtain inflator modules, if equipped. Refer to DISABLING & ACTIVATING AIR BAG SYSTEM in AIR BAG RESTRAINT SYSTEMS article in RESTRAINTS.
NOTE:
Refer to Fastener Notice
in Cautions and Notices.