LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2002 >> SC1 Automatic >> Repair and Diagnosis (Single Page) >> Electrical >> Wiring Diagrams >> Wiring Systems -- "S" Series (General Information) >> Diagnostic Information and Procedures >> Probing Electrical Connectors

Probing Electrical Connectors

    Fig 1: Installing Service Probe Terminal Housing
    GM862318Courtesy of GENERAL MOTORS CORP.
  1. Place the cable into the V-slot of the terminal.
  2. Press the cable into the V-slot by hand and initiate closing the cover.
    3. Fig 2: Closing Service Probe Terminal Housing
    GM862323Courtesy of GENERAL MOTORS CORP.
  3. Close the cover completely by pressing the cable into the diagnostic service probe terminal with pliers until the cover locks shut. A snap should be felt or heard when the cover locks.
    4. Fig 3: Inserting Multimeter Probe Into Service Probe Terminal Housing
    GM862333Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Once the probe is installed, it should not be removed. The diagnostic service probe is designed to stay on the wire permanently. The gel material inside the probe will seal the wire and allow the wire to be probed several times.
  4. To probe the wire, insert the multimeter probe into the housing through the gel to contact the terminal. The housing has a thin wall of material to pierce with the multimeter probe. In some locations the multimeter probe should be used to pierce the probe opening, before the probe is installed on the wire.
scientia non olet · About LEMON Manuals