LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2002 >> SC1 Automatic >> Repair and Diagnosis (Single Page) >> Body & Frame >> Sun Roof/T-Top/Convertible Top >> Roof -- "S" Series >> Repair Instructions >> Roof Front Drip Molding Replacement - Left Side >> Removal Procedure

Removal Procedure

    Fig 1: Windshield Frame Filler Panel
    GM866809Courtesy of GENERAL MOTORS CORP.
  1. Remove the windshield frame filler panel by removing the screw, then sliding the panel upward.
    2. Fig 2: Roof Front Drip Molding - Left Side & Retaining Screws
    GM867114Courtesy of GENERAL MOTORS CORP.
  2. Pry down on the window encapsulated molding on the window assembly rear side quarter to reveal the retaining screws.
  3. Remove the retaining screws (2) behind the window encapsulated molding back into place.
  4. Open the doors and remove the remaining retaining screws.
  5. Remove the drip rail.
    1. Carefully remove the rear end of the drip rail behind the rear quarter panel.
    2. Remove the rear end of the drip rail from behind the window assembly rear side quarter panel.
    3. Remove the front end of the drip rail from behind the front fender.
scientia non olet · About LEMON Manuals