Removal Procedure
Courtesy of GENERAL MOTORS CORP.
- Remove the rear seat cushion. Refer to Rear Seat Cushion Replacement (Coupe)
or Rear Seat Cushion Replacement (Sedan/Wagon)
in Seats.
Courtesy of GENERAL MOTORS CORP.
- Remove the shoulder belt anchor fastener.
Courtesy of GENERAL MOTORS CORP.
- Partially remove the rearward most section of the front upper garnish molding to expose the lock pillar upper garnish molding.
- Starting at the front, pull firmly at the body lock pillar upper garnish molding clip locations to disengage the clips.
- Slide the shoulder belt unit out of the opening in the molding and remove the molding.