LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2002 >> SC1 Automatic >> Repair and Diagnosis (Single Page) >> Body & Frame >> Exterior/Interior Trim >> Interior Trim -- "S" Series >> Repair Instructions >> Body Lock Pillar Upper Molding Replacement (Wagon) >> Removal Procedure

Removal Procedure

    Fig 1: Headliner At Left Side D-Pillar Location
    GM866919Courtesy of GENERAL MOTORS CORP.
  1. Remove the rear header trim panel by pulling at the clip locations to disengage the attaching clips.
    2. Fig 2: Corner Upper Garnish Moldings
    GM867189Courtesy of GENERAL MOTORS CORP.
  2. Remove the body rear corner trim panel assembly by pulling at the clip locations to disengage the attaching clips.
    3. Fig 3: Lock Pillar Upper Moldings
    GM879824Courtesy of GENERAL MOTORS CORP.
  3. For 1st design vehicles, starting at the rear of the body lock pillar molding, pull at the clip locations to disengage.
  4. Slide the molding out from under the front upper garnish molding to remove.
    5. Fig 4: Body Lock Pillar Upper Garnish Molding
    GM869300Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Before removing, note the position of the door weatherstrip over the molding edge.
  5. For 2nd design vehicles, pull at the clip locations to disengage.
scientia non olet · About LEMON Manuals