LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2002 >> SC1 Automatic >> Repair and Diagnosis (Single Page) >> Body & Frame >> Exterior Body Panels >> Bumpers -- "S" Series >> Repair Instructions >> Front Bumper Impact Bar Replacement >> Installation Procedure

Installation Procedure

    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Position the impact bar to the spaceframe. Install the attaching nuts.

    Tighten:  Tighten to 30 N.m (22 lb ft).

  2. Install the nut to stud attaching the tow hook to the impact bar.

    Tighten:  Tighten to 30 N.m (22 lb ft.).

    3. Fig 1: Fog Lamp
    GM866769Courtesy of GENERAL MOTORS CORP.
  3. Install the fog lamps, if equipped. Refer to Fog Lamp Capsule Replacement - Front in Lighting Systems.
    4. Fig 2: Fascia Support-To-Bumper Impact Bar Attaching Nuts
    GM866692Courtesy of GENERAL MOTORS CORP.
  4. Install the fascia support. Refer to Fascia Support Replacement .
    5. Fig 3: Upper And Lower Fascia Retainers (Coupe)
    GM866329Courtesy of GENERAL MOTORS CORP.
  5. Install the front fascia. Refer to Front Bumper Fascia Replacement (Sedan/Wagon)  or Front Bumper Fascia Replacement (Coupe) .
scientia non olet · About LEMON Manuals