LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2002 >> SC1 Automatic >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Seats -- "S" Series >> Repair Instructions >> Rear Split Folding Seat Back Replacement >> Removal Procedure

Removal Procedure

    Fig 1: Seat Back
    GM867332Courtesy of GENERAL MOTORS CORP.
  1. On the SW2 with rear headrests, remove the headrests. Refer to Head Restraint Replacement (SL2/SC2/SW2) .
  2. Release the seat back latch and tilt the seat forward.
  3. Disengage the cargo floor carpet from the seat back.
    4. IMPORTANT: The rear seat back attachments have an easyload outer bracket that allows the rear seat back to snap into position upon installation. It is necessary to gently pry this easyload bracket outward to remove the rear seat back. It is important not to use excessive force to pry on the bracket or bracket may become damaged. Move the bracket only enough to lift the seat back from the vehicle. If the bracket has been moved outward too much, gently reposition the bracket to ensure proper retention of the rear seat back to the bracket.
  4. Using a large flat-bladed screwdriver, gently pry the outer seat back easyload bracket outboard just enough for the seat back pin to disengage from the easyload bracket.
  5. Lift the seat back up and remove it from the vehicle.
scientia non olet · About LEMON Manuals