Installation Procedure
- Turn the replacement seat cover inside out. Transfer all listing wires to the same locations in the new cover.
- Center the seat cover over the pad.
- Align all listing wires in the seat cover with the grooves in the cushion pad.
- Begin at the inner listing wires of the cover and install hog rings to secure the cushion cover to the cushion pad wires. Check the fit of the cover after each listing wire is secured.
- Press down at the hook-and-loop fastener attachment locations in the seat cushion cover to secure it to the seat cushion.
- Check the fit of the seat cushion cover. Pull on the cover where necessary to remove any wrinkles.
- If both pads are being replaced, repeat procedure for the remaining seat cushion cover.
- Install the seat cushion to the seat frame.
- Hook the listing wire, extending through the bottom listing wire pocket on the seat cushion cover to the frame wire.
- Secure the seat cushion cover and the seat cushion to the frame with new hog rings.
- Install the rear seat cushion. Refer to Rear Seat Cushion Replacement (Coupe) or Rear Seat Cushion Replacement (Sedan/Wagon) .
IMPORTANT:
Be certain the hog rings hook the seat cover and cushion to the frame at the rear of the seat cushion assembly. The hog rings at the front of the seat cushion assembly do not hook into the pad.