Removal Procedure
Courtesy of GENERAL MOTORS CORP.
- Remove the 20A LIGHTER fuse.
- Remove the right lower trim panel extension by pulling outward at the dual lock location.
- Rotate the panel outward to disengage from the console.
- Remove the fuse.
Courtesy of GENERAL MOTORS CORP.
- Obtain the J 42059
.
Courtesy of GENERAL MOTORS CORP.
- Lift the tether cap from the cigar lighter receptacle.
- Locate the two small square holes in the receptacle.
- Hold the J 42059
at a 30° angle as it is inserted into the receptacle.
- Position one end of the T end of the J 42059
in one hole, then the other hole. A slight resistance will be felt as the second end is inserted into the hole.
- Pull the receptacle straight out.
- Disengage the retaining tabs and disconnect the power outlet connector.