Setting the Time of Day (Clock): Notes
- Push and hold the RCL (Recall) button.
- While holding the RCL button, push the left side of the auto tone button until the correct hour appears.
- While holding the RCL button, push the right side of the auto tone button until the correct minute appears.
- Release the RCL button when complete.
- Dimming
-
All radios feature continuously dimmable nighttime incandescent back lighting for the graphics on the pushbuttons and trimplate. The incandescent back lighting voltage is supplied from the vehicle light switch and is grounded through the radio wiring and the radio ground strap. The internal lamps are controlled by the high side pulse width modulated (PWM) dimmer control circuit through the BCM.
The LCD is backlit whenever ignition voltage is applied regardless if the radio power knob is on or off. When the vehicle's exterior lights are turned On, the interior lights knob, which is found to the left of the steering wheel, can be turned to adjust the illumination of the radio. Turning the knob clockwise makes the light get brighter, while turning the knob counter-clockwise results in the light being dimmer. - Remote Compact Disc Changer/Player Compatible
-
Radio functions operate a remotely located 6-disc CD changer/player.
- Theft Deterrent
-
On-board diagnostics (OBD) are available to check:
- If any diagnostic trouble codes (DTCs) have been set.
- If speakers are functioning correctly at two different tones.
- If all segments on the LCD light up.
- If all buttons are working.
- What equalization mode the radio is set at.
- What antenna signal strength is being read by the radio.
- If the CD changer/player is connected and communicating with the radio.