Output Shaft Speed Sensor Installation

WARNING: This page is about a different car, the 2003 Saturn LW300, 2003 Saturn LW200, 2003 Saturn L300, and 2003 Saturn L200. However, it is still accessible from the selected car via links, so may be relevant.

Inspect the vehicle speed sensor (62) for damage to the sensor, the electrical connector, or the O-ring (63).

Fig 1: Inspecting Output Shaft Speed Sensor
Courtesy of GENERAL MOTORS CORP.
Clean and dry the vehicle speed sensor (62).
Install the O-ring (63) onto the speed sensor (62).

Fig 2: Installing Output Shaft Speed Sensor & O-Ring
Courtesy of GENERAL MOTORS CORP.
Install the speed sensor (62) into the transmission case.
NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
Install the speed sensor stud (61).
Tighten: Tighten the speed sensor stud to 12 N.m (9 lb ft).