LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2002 >> LW200 Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 312 (Automatic Transaxle - 4T40-E/4T45-E - Diagnosis (DTC P0719 To DTC P0757)) >> Diagnostic Trouble Codes >> DTC P0719 (3.0L - L81) >> Test Description

Test Description

WARNING: This page is about a different car, the 2003 Saturn LW300, 2003 Saturn LW200, 2003 Saturn L300, and 2003 Saturn L200. However, it is still accessible from the selected car via links, so may be relevant.

The numbers below refer to the step numbers on the diagnostic table.

  1. 2:  Disconnecting the brake switch connector, and observing a status change, isolates the brake switch as the source of the DTC.
  2. 3:  This step inspects the signal circuit for a short to voltage, if the brake switch status on the scan tool did not change in Step 2.
  3. 4:  If the brake switch is properly adjusted, then the brake switch must be replaced.
  4. 5:  Replace the TCM only after you have completed the preceding diagnostic steps.
DTC P0719 (3.0L - L81)

Step Action Value(s) Yes No
1 Did you perform the Diagnostic System Check - Engine Controls? - Go to Step 2  Go to DIAGNOSTIC SYSTEM CHECK - ENGINE CONTROLS in Self-Diagnostics - 3.0L or DIAGNOSTIC SYSTEM CHECK -- ENGINE CONTROLS in Self-Diagnostics - 2.2L
2 
  1. Install a scan tool.
  2. Turn ON the ignition, with the engine OFF.
    IMPORTANT: Before clearing the DTC, use the scan tool in order to record the Failure Records. Using the Clear Info function erases the Failure Records from the TCM.
  3. Record the DTC Failure Records.
  4. Clear the DTC.
  5. Select Brake Switch on the scan tool.
  6. Disconnect the brake switch connector.
Does the brake switch status change from Closed to Open?		 - Go to Step 4  Go to Step 3 
3  Test the signal circuit (CKT 20) of the brake switch for a short to voltage.
Refer to Testing for a Testing for a Short to Voltage and Wiring Repairs in Wiring Systems.
Did you find and correct the condition?		 - Go to Step 6  Go to Step 5 
4  Replace the brake switch.
Refer to STOP LAMP SWITCH REPLACEMENT in Lighting Systems.
Did you complete the replacement?		 - Go to Step 6  -
5  Replace the TCM.
Refer to Transmission Control Module (TCM) Replacement .
Did you complete the replacement?		 - Go to Step 6  -
6 Perform the following procedure in order to verify the repair:
  1. Select DTC.
  2. Select Clear Info.
  3. Operate the vehicle under the following conditions:
    • Turn ON the ignition, with the engine OFF.
    • Apply the brake pedal for at least 2 seconds.
  4. Select Specific DTC.
  5. Enter DTC P0719.

Has the test run and passed?		 - Go to Step 7  Go to Step 2 
7 With the scan tool, observe the stored information, capture info and DTC info.
Does the scan tool display any DTCs that you have not diagnosed?		 - Go to DIAGNOSTIC TESTS in Self-Diagnostics - 2.2L or DIAGNOSTIC TESTS in Self-Diagnostics - 3.0L System OK
scientia non olet · About LEMON Manuals