LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2002 >> L300 >> Repair and Diagnosis >> External Pages >> Different car >> Section 272 (Automatic Transaxle - 4T40-E/4T45-E - Service, Repair, Removal & Installation) >> Repair Instructions >> Drive, Driven Sprockets and Drive Link Disassemble

Drive, Driven Sprockets and Drive Link Disassemble

WARNING: This page is about a different car, the 2003 Saturn LW300, 2003 Saturn LW200, 2003 Saturn L300, and 2003 Saturn L200. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the turbine shaft to drive sprocket snap ring (35).
  2. Remove the drive sprocket (37) from the turbine shaft (39).
    Fig 1: Disassembling Drive, Driven Sprockets & Drive Link
    GM20313Courtesy of GENERAL MOTORS CORP.
  3. Remove the three Teflon seals (33 and 40) from the turbine shaft.
  4. Discard the Teflon seals (33 and 40).
  5. Inspect the drive sprocket (37), the driven sprocket (91), the drive link assembly (36), and the turbine shaft (39) for damage or excessive wear.
    Fig 2: Inspecting Drive Sprocket, Driven Sprocket, Drive Link Assembly & Turbine Shaft
    GM25658Courtesy of GENERAL MOTORS CORP.
  6. Inspect the seal grooves for damage.
  7. Inspect the thrust washers for damage or excessive wear.
  8. Clean and dry each of the components.
scientia non olet · About LEMON Manuals