Conditions for Clearing the MIL/DTC
WARNING: This page is about a different car, the 2003 Saturn LW300, 2003 Saturn LW200, 2003 Saturn L300, and 2003 Saturn L200. However, it is still accessible from the selected car via links, so may be relevant.
- The ECM turns OFF the MIL after the third consecutive drive trip in which the TCM does not send a MIL illumination request.
- A scan tool can clear the MIL/DTC.
- The TCM clears the DTC from TCM history if the vehicle completes 40 warm-up cycles without an emission related diagnostic fault occurring.
- The TCM cancels the default actions when the ignition switch is OFF long enough in order to power down the TCM.
DTC P0601 (3.0L (L81))
| Step | Action | Values | Yes | No |
|---|---|---|---|---|
| 1 | Did you perform the Diagnostic System Check - Engine Controls? | - | Go to Step 2 | Go to DIAGNOSTIC SYSTEM CHECK - ENGINE CONTROLS in Self-Diagnostics - 3.0L or DIAGNOSTIC SYSTEM CHECK -- ENGINE CONTROLS in Self-Diagnostics - 2.2L |
| 2 |
|
- | Go to Step 3 | - |
| 3 | Replace the TCM. Refer to Transmission Control Module (TCM) Replacement Is the replacement complete? |
- | Go to Step 4 | - |
| 4 | Perform the following procedure in order to verify the repair:
Has the test run and passed? |
- | Go to Step 5 | Go to Step 2 |
| 5 | With the scan tool, observe the stored information, capture info and DTC info. Does the scan tool display any DTCs that you have not diagnosed? |
- | Go to DIAGNOSTIC TESTS in Self-Diagnostics - 2.2L or DIAGNOSTIC TESTS in Self-Diagnostics - 3.0L | System OK |