LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2002 >> L100 >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Air Bag Restraint Systems >> Disabling & Activating Air Bag System >> Disabling System

Disabling System

NOTE: When AIR BAG fuse is removed and ignition is on, AIR BAG warning light will be on. This does not indicate a system malfunction.
  1. Turn steering wheel to place vehicle wheels in straight-ahead position.
  2. Remove IGN1 fuse (10-amp) from under hood fuse block. Remove driver-side knee bolster (steering column filler). Remove Connector Position Assurance (CPA) clips and disconnect driver-side and passenger-side air bag module Yellow 2-pin connectors at base of steering column. See Fig 1.
  3. On models equipped with head impact air bags, remove upper seat belt shoulder bolt from left and right rear seat belts. Fold down rear seat. Remove upper quarter panel trim assembly from driver-side and passenger-side C-pillars on sedan or D-pillars on wagon. Remove Connector Position Assurance (CPA) clips and disconnect driver-side and passenger-side for head impact air bag module Yellow 2-pin connectors. See Fig 2.
Fig 1: Identifying Driver-side & Passenger-side Air Bag Module Yellow 2-pin Connectors
G99E00319Courtesy of GENERAL MOTORS CORP.
Fig 2: Identifying Side Impact Air Bag Module Yellow 2-pin Connector (Sedan Shown; Wagon Is Similar)
G99A23382Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals