Diagnostic Procedure
- If SIR diagnostic system check has been performed, go to next step. If SIR diagnostic system check has not been performed, go to SIR DIAGNOSTIC SYSTEM CHECK .
- Install scan tool. Turn ignition on. Using scan tool, request SIR DTC display. If DTC 0081 is not current, go to next step. If DTC 0081 is current, go to step 4.
- Inspect wire harness and wire harness connectors. Repair as necessary. See WIRE REPAIR . Go to step 5.
- Turn ignition off. Replace SIS. See SIDE IMPACT SENSOR (SIS) under REMOVAL & INSTALLATION. Go to next step.
- Reconnect all SIR components. Ensure that all components are properly mounted. Using scan tool, clear all SIR DTCs. Go to SIR DIAGNOSTIC SYSTEM CHECK .