LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2000 >> SW2 Automatic >> Repair and Diagnosis (Single Page) >> Heating, Ventilation & A/C (HVAC) >> General Servicing >> HVAC System - Compressor Refrigerant Oil Checking >> Checking Compressor Oil >> DELPHI-Thermal (HARRISON) Hd6/Ht6/HU6 & Hd6/Hr-6HE 6-CYL., V5 5-CYL. & V7 7-CYL.

DELPHI-Thermal (HARRISON) Hd6/Ht6/HU6 & Hd6/Hr-6HE 6-CYL., V5 5-CYL. & V7 7-CYL.

NOTE: Replacement compressor may be shipped with 8-9 ounces of refrigerant oil. Drain shipping refrigerant oil into a clean container and retain for use.
  1. If possible, operate system for several minutes to stabilize system. Turn engine off. Discharge A/C system, using approved refrigerant recovery/recycling equipment. Remove A/C compressor. Drain and measure refrigerant oil from old compressor through suction and discharge ports, and drain plug. Add specified amount of oil to replacement compressor. Install compressor drain plug and compressor.
  2. NOTE: Approximately 3.0 ounces of refrigerant oil, suspended in refrigerant, will be lost due to a large, abrupt leak. When replacing a faulty A/C component, add amount of oil specified for component plus 3.0 ounces to compensate for oil loss. If oil cannot easily be added to component, add it to accumulator.
  3. When replacing other A/C components, add specified amount of refrigerant oil to component before installation. See DELPHI-THERMAL (HARRISON) HD6/HT6/HU6, HD6/HR-6HE 6-CYL., V5 5-CYL. & V7 7-CYL. COMPONENT REFRIGERANT OIL CAPACITIES (2000)  or DELPHI-THERMAL (HARRISON) HD6/HT6/HU6, HD6/HR-6HE 6-CYL., V5 5-CYL. & V7 7-CYL. COMPONENT REFRIGERANT OIL CAPACITIES (2001)  table. Evacuate and charge system. Perform leak test. Ensure A/C system is operating properly.
DELPHI-THERMAL (HARRISON) HD6/HT6/HU6, HD6/HR-6HE 6-CYL., V5 5-CYL. & V7 7-CYL. COMPONENT REFRIGERANT OIL CAPACITIES (2000)

Component Ounces
Cars
Accumulator/Receiver-Drier
"G" & "Y" Bodies 3.5
"F", "N" & "W" Bodies (1)
"C", "E", "H" & "J" Bodies 3.0
"S" Body 2.0
"V" Body (2) 1.0
Compressor
"C", "E", "V" & "Y" Bodies (2) 2.0
"F", "G", "H", "P", "N" & "W" Bodies (3)
"J" Body 2.8
"S" Body (4) 2.0
Condenser
Except "C", "J", "S" & "W" Bodies 1.0
"C", "J", "S" & "W" Bodies 2.0
Evaporator
Except "C", "E" & "S" Body 3.0
"C", "E" & "S" Body 2.0
Refrigerant Hose/Line
"S" Body 1.0
Sudden Refrigerant Loss
"W" Body (5)
Trucks & Vans
Accumulator/Receiver-Drier
Except "C" & "K" (New Style), "S/T" & "U" Series 3.5
"C" & "K" Series (New Style) 2.0
"S/T" Series (4)
"G" Series (1)
"U" Series (6)
Compressor
Except "U" Series (3)
"U" Series (2)
Compressor Suction/Discharge Hose
"S/T" Series 1.0
Condenser
Except "U" Series 1.0
"U" Series (6)
Evaporator
Except "U" Series 3.0
"U" Series (6)
(1) Add amount drained from old accumulator/receiver-drier plus one ounce.
(2) Add amount drained from component or amount specified, whichever is greater.
(3) Drain and measure refrigerant oil from old compressor. If old compressor had less than one ounce, add 2 ounces of refrigerant oil to replacement compressor. If old compressor had more than 2 ounce, add the same amount of refrigerant oil to replacement compressor.
(4) Add 2 ounces of refrigerant oil plus amount drained from old component.
(5) Add 3 ounces of refrigerant oil plus amount specified for replacement component.
(6) Information not available from manufacturer.
DELPHI-THERMAL (HARRISON) HD6/HT6/HU6, HD6/HR-6HE 6-CYL., V5 5-CYL. & V7 7-CYL. COMPONENT REFRIGERANT OIL CAPACITIES (2001)

Component Ounces
Cars
Accumulator/Receiver-Drier
"C" & "E" Bodies (1) 2.0
"F", "N", "V" & "W" Bodies (2)
"G", "H", "K", "M", "Y" & "Z" Bodies 3.5
"J" Body 3.0
"S" Body 2.0
"V" Body 1.0
Compressor
"C", "E" & "V" Body (1) 2.0
"F", "G", "H", "J", "P", "N" & "W" Bodies (4)
"J" Body 2.8
"K" & "Y" Bodies 2.0
"S" Body (5) 2.0
Condenser
"C" & "E" Bodies (1) 1.0
Except "C", "E", "J" & "S" Bodies 1.0
"J" & "S" Body 2.0
Evaporator
"C" & "E" Bodies (1) 3.0
"E" & "S" Bodies 2.0
Except "E" & "S" Bodies 3.0
Refrigerant Hose/Line
"S" Body 1.0
Sudden Refrigerant Loss
"C" & "W" Body (6)
Trucks & Vans
Accumulator/Receiver-Drier
"C", "K" & "S/T" Series (1) 2.0
"G" Series
With Accumulator (1) 2.0
With Receiver/Drier (1) 1.0
"A/B" & "U" Series (1) 0.4
Compressor
Except "A/B" & "U" Series (1) 2.0
"A/B" Series (3) 2.7
"U" Series
With Front A/C (3) 2.7
With Front & Rear A/C (3) 3.4
Condenser
Except "U" Series (1) 1.0
"A/B" & "U" Series (1) 0.7
Evaporator (Front Or Rear) (1) 3.0
(1) Add amount drained from component or amount specified, whichever is greater.
(2) Add amount drained from old accumulator/receiver-drier plus one ounce.
(3) Add amount drained from compressor or amount specified, whichever is greater. Replacement compressor is shipped with 2.7 ounces for front A/C or 3.4 ounces for front and rear A/C.
(4) Drain and measure refrigerant oil from old compressor. If old compressor had less than one ounce, add 2 ounces of refrigerant oil to replacement compressor. If old compressor had more than 2 ounce, add the same amount of refrigerant oil to replacement compressor.
(5) Add 2.0 ounces of refrigerant oil plus amount drained from old compressor.
(6) Add 3.0 ounces of refrigerant oil plus amount specified for replacement component.